BMI160 6-axis Rate Gyro Gravity Accelerometer Sensor Module

GY-BMI160 6-axis Rate Gyro Gravity Accelerometer Sensor Module with I²C SPI Communication Protocol 3-5V

Description

The module uses Bosch’s new BMI160 6-axis inertial motion sensor in a MEMS sensor package that integrates the top 16-bit 3-axis accelerometer with an ultra-low power 3-axis gyroscope. The module can output acceleration data (acceleration values detected by the device in the X, Y, and Z directions) and gyroscope data (the speed at which the device rotates around the X, Y, and Z axes). When accelerometers and gyroscopes operate in full-speed mode, typical power consumption is as low as 950μA,which is only 50% or less of the power consumption of similar products on the market.

Designed for smartphones, tablets, and wearable devices, the Bosch BMI160 includes a built-in smart step counter algorithm that reads the number of steps directly through the registers. The built-in 3-axis acceleration and 3-axis gyroscope enable motion detection such as running and fitness. Module built-in LDO power management chip,VIN supports 3.2~ 6V wide voltage supply, also has a separate 3.3V interface,compatible with Arduino 3.3V and 5V controller direct drive.

Specifications

• Working voltage: 3.2V~6V
• Current consumption: <1mA
• Interface mode: 2.54 pitch pin header
• Aceleration optional ruler: ±2g/±4g/±8g/±16g
• Gyro optional scale: ±125°/s, ±250°/s,±500°/s,±1000°/s,±2000°/s
• Accelerometer zero drift:±40mg
• Gyroscope zero drift:±10°/s
• Programmable frequency: 25/32Hz~1600Hz
• 6D detection and positioning
• 16-bit data output
• Impact resistance: 10,000 gx 200μs
• 2 independent programmable interrupt generators
• Built-in 1024 byte FIFO
• Working temperature: -40°C~+85°C

Pin definition

Schematic