IR Infrared Flame Detection Sensor Module

IR Infrared 1 Channel 5V or 12V Flame Detection Sensor Module /Fire Alarm Sensor Relay Module For Arduino

PARAMETERS

• Supply voltage: 5VDC/12VDC
• Current: Greater than 150mA
• Load: 250V 10A AC or 30V 10A DC

FEATURES

• The flame can be detected or the light source with a wavelength ranging from 760 nm to 1100 nm. The lighter can test the flame at a distance of 80cm, and the larger the flame, the farther the test distance
• Detection Angle of about 60 degrees, especially sensitive to flame spectrum
• Adjustable sensitivity
• Direct trigger relay of comparator output
• External dimension: 50x26mm, 19mm thick, with fixing bolt hole for easy installation
• Output with blue wiring block, wiring square Product Use:All kinds of flame, fire source detection, relay output, can be connected to 220V large current equipment electrical appliances

DIRECTIONS FOR USE

• The flame sensor is sensitive to the flame, is also responsive to sunlight,generally used for fire alarm and other purposes.
• By adjusting the potentiometer, the intensity of sensor induced flame can be set. When the flame exceeds the set threshold, the relay pulls in and the common end is connected with the constant start.
• The three ports of common end, normally open and normally closed areequivalent to a double-control switch. When the relay first has electricity ,the common end conducts with the normal beginning; when there is no electricity, the common end conducts with the normally closed end.
• Keep a certain distance between the sensor and the flame to avoid temperature damage to the sensor. The test flame is 80CM away from the lighter; the larger the flame, the farther the test distance is.

WIRING DIAGRAM

When the flame intensity is higher than the set value, the relay will pull inand the bulb will light up. When the flame intensity is lower than the set value, the relay will disconnect and the lamp will not light up (wiring method is shown in the figure only).It is used for high-voltage connection.

When the flame intensity is higher than the set value, the relay will pull inand the bulb will light up. When the flame intensity is lower than the set value, the relay will disconnect and the lamp will not light up (wiring method is shown in the figure only).