RENESAS-F6522AVGI

Part #RENESAS-F6522AVGI
Download 
RENESAS-F6522AVGI
8-Ch Tx Active Beamforming IC  
27.5 – 31.0 GHz  
F6522  
Short-Form Datasheet  
Description  
Features  
The F6522 is an 8-channel transmit active beamforming RFIC  
designed for application in Ka-Band SATCOM planar phased array  
antennas. The IC has a single common RF input port and eight  
output channels. The eight independently controlled output  
channels can drive eight single-polarized elements or four dual-  
polarized elements of an electronically scanned array (ESA). Each  
channel has 6 bits of digital phase control covering 360° and 25dB  
of gain control with a minimum step size of 0.2dB, enabling precise  
beam pattern and polarization control.  
.
.
.
.
.
.
.
.
.
.
.
.
.
27.5 – 31.0GHz operation  
Supports 4 dual-pol elements or 8 single-pol  
360° phase control with 6-bit resolution  
25dB gain control with 0.2dB minimum step  
28dB small signal gain  
11dBm output P1dB  
2.3V nominal single supply input  
Standard 1.8V digital logic  
Operating from a single supply of 2.1 – 2.5V, the RFIC has 28dB of  
nominal small signal gain with a typical P1dB of 11dBm per  
channel. The F6522 is highly efficient and features a low power  
standby mode as well as independent enable controls on every  
channel. The device’s SPI bus and control pins operate from  
standard 1.8V logic at speeds up to 50MHz. Advanced digital  
modes and large on-chip memory allows for < 100ns beam position  
switching times at the array level, greatly reducing dead time and  
latency.  
Temperature compensation  
Temperature sensor with digital readout  
Advanced digital modes with fast beam steering  
On-chip beam-state memory  
3.8
×
4.6
×
0.9 mm, 62-pin FC-BGA package  
Block Diagram  
Finally, the compact and CTE-matched FC-BGA organic package  
with all single-ended 50ohm matched RF ports greatly simplifies  
the physical integration of the F6522 onto large antenna panels.  
Typical Applications  
.
.
.
Phased array antennas  
Ka-band SATCOM terminals  
Aerospace and maritime  
© 2020 Renesas Electronics Corporation  
1
March 13, 2020  

F6522 Short-Form Datasheet  
Ordering Information  
Orderable Part Number  
Package  
MSL Rating  
Carrier Type  
Tray  
Temperature  
-40°C to +85°C  
-40°C to +85°C  
F6522AVGI  
3
3
3.8
×
4.6
×
0.9 mm 62-BGA  
3.8
×
4.6
×
0.9 mm 62-BGA  
F6522AVGI8  
Reel  
F6522EVS  
F6522 Evaluation System. Includes Digital Interface Board, RF Evaluation Board, USB Cable, Power Supply  
Cable, Digital Interconnect Cable, Evaluation Software, Device Drivers and RF De-embed Files.  
© 2020 Renesas Electronics Corporation  
2
March 13, 2020  

IMPORTANT NOTICE AND DISCLAIMER  
RENESAS ELECTRONICS CORPORATION AND ITS SUBSIDIARIES (“RENESAS”) PROVIDES TECHNICAL  
SPECIFICATIONS AND RELIABILITY DATA (INCLUDING DATASHEETS), DESIGN RESOURCES (INCLUDING  
REFERENCE DESIGNS), APPLICATION OR OTHER DESIGN ADVICE, WEB TOOLS, SAFETY INFORMATION, AND  
OTHER RESOURCES “AS IS” AND WITH ALL FAULTS, AND DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED,  
INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILIT
Y
,
F
ITNESS FOR A  
PARTICULAR PURPOSE, OR NON-INFRINGEMENT OF THIRD PARTY INTELLECTUAL PROPERTY RIGHTS.  
These resources are intended for developers skilled in the art designing with Renesas products.
Y
o
u are solely responsible  
for (1) selecting the appropriate products for your application, (2) designing, validating, and testing your application, and (3)  
ensuring your application meets applicable standards, and any other safet
y
, security, or other requirements. These  
resources are subject to change without notice. Renesas grants you permission to use these resources only for  
development of an application that uses Renesas products. Other reproduction or use of these resources is strictly  
prohibited. No license is granted to any other Renesas intellectual property or to any third party intellectual propert
y
.  
Renesas disclaims responsibility for, and you will fully indemnify Renesas and its representatives against, any claims,  
damages, costs, losses, or liabilities arising out of your use of these resources. Renesas’ products are provided only subject  
to Renesas’
T
e
rms and Conditions of Sale or other applicable terms agreed to in writing. No use of any Renesas resources  
expands or otherwise alters any applicable warranties or warranty disclaimers for these products.  
(Rev.1.0 Mar
 
2020)  
Corporate Headquarters  
Contact Information  
TOYOSU FORESIA, 3-2-24
T
o
yosu,  
Koto-ku,
T
o
kyo 135-0061, Japan  
Trademarks  
Renesas and the Renesas logo are trademarks of Renesas  
Electronics Corporation. All trademarks and registered  
trademarks are the property
 
of their respective owners.  
© 2020 Renesas Electronics Corporation. All rights reserved.